| Parts | Standard oil-mist lubricator |
| Type of filling | Semi-automatic oil filling during operation,Manual oil filling |
| Protective guard | with protective guard |
| Housing | Polyamide |
| Reservoir | Polycarbonate |
| Sealing material | Acrylonitrile butadiene rubber |
| suitable for ATEX | |
| Nominal flow Qn | 2800 l/min |
| Compressed air connection | G 1/4 |
| Version | Oil-mist lubricator, Can be assembled into blocks |
| Parts | Standard oil-mist lubricator |
| Mounting orientation | vertical |
| Certificates | suitable for ATEX |
| Working pressure min./max. | 0,5 … 16 bar |
| Ambient temperature min./max. | -10 … 50 °C |
| Medium temperature min./max. | -10 … 50 °C |
| Medium | Compressed air Neutral gases |
| Lubricator reservoir volume | 40 cm³ |
| Type of filling | Semi-automatic oil filling during operation Manual oil filling |
| Weight | 0,229 kg |
| The pressure dew point must be at least 15 °C under ambient and medium temperature and may not exceed 3 °C . Electrical level detection only with ST6 sensor with reed contact, sensor holder included in the scope of the delivery. Sensor not included in scope of delivery, sensor installation prepared. The entire preset drip quantity enters the pressure system. Manual oil filling possible during operation at a maximum operating pressure of 10 bar. Suitable for use in Ex zones 1, 2, 21, 22. Note: Polycarbonate reservoirs are susceptible to solvents, supplementary information can be found at “Customer information”. A change in the flow direction (from air supply on the left to air supply on the right) occurs by rotating installation by 180° about the vertical axis. Please see the operating instructions for further details. |
|
| Oil dosing at 1000 l/min | 1-2 drops |
| Material |
|---|
| Housing | Polyamide |
| Front plate | Acrylonitrile butadiene styrene |
| Seals | Acrylonitrile butadiene rubber |
| Threaded bushing | Die cast zinc |
| Reservoir | Polycarbonate Die cast zinc |
| Protective guard | Polyamide |
