| Parts | Pre-filter |
| Condensate drain | fully automatic, open without pressure |
| filter porosity | 0.3 µm |
| Housing | Polyamide |
| Reservoir | Polycarbonate |
| Sealing material | Acrylonitrile butadiene rubber |
| suitable for ATEX | |
| Nominal flow Qn | 2200 l/min |
| Compressed air connection | G 3/4 |
| Version | Pre-filter, Can be assembled into blocks |
| Parts | Pre-filter |
| Mounting orientation | vertical |
| Certificates | suitable for ATEX |
| Working pressure min./max. | 1,5 … 16 bar |
| Ambient temperature min./max. | -10 … 50 °C |
| Medium temperature min./max. | -10 … 50 °C |
| Medium | Compressed air Neutral gases |
| Filter reservoir volume | 87 cm³ |
| Filter element | exchangeable |
| filter porosity | 0,3 µm |
| Condensate drain | See table |
| Weight | See table |
| The pressure dew point must be at least 15 °C under ambient and medium temperature and may not exceed 3 °C . Note: Polycarbonate reservoirs are susceptible to solvents, supplementary information can be found at “Customer information”. Suitable for use in Ex zones 1, 2, 21, 22. A change in the flow direction (from air supply on the left to air supply on the right) occurs by rotating installation by 180° about the vertical axis. Please see the operating instructions for further details. |
|
| Recommended pre-filtering | 5 µm |
| Max. achievable compressed air class acc. to ISO 8573-1:2010 | 2 : – : 3 |
| Material |
|---|
| Housing | Polyamide |
| Front plate | Acrylonitrile butadiene styrene |
| Seals | Acrylonitrile butadiene rubber |
| Threaded bushing | Die cast zinc |
| Reservoir | Polycarbonate Die cast zinc |
| Protective guard | Polyamide |
| Filter insert | Impregnated paper |
