| Version | Poppet valve |
| Housing | Die cast zinc |
| Sealing material | Acrylonitrile butadiene styrene |
| Protection class | IP65 |
| Qn 1?2 | 2000 l/min |
| Qn 2?3 | 800 l/min |
| Compressed air connection input | G 1/4 |
| Compressed air connection output | G 1/4 |
| Version | Poppet valve, Can be assembled into blocks |
| Parts | Filling valve, 3/2-directional valve, electrically operated |
| Nominal flow 1 ? 2 | 2000 l/min |
| Nominal flow 2 ? 3 | 800 l/min |
| Working pressure min./max. | 2,5 … 10 bar |
| Medium | Compressed air Neutral gases |
| Medium temperature min./max. | -10 … 60 °C |
| Ambient temperature min./max. | -10 … 60 °C |
| Pilot | Internal |
| Sealing principle | Soft sealing |
| Max. particle size | 5 µm |
| Protection class acc. to DIN EN 61140 with plug | IP65 |
| Duty cycle | 100 % |
| Weight | See table |
| The pressure dew point must be at least 15 °C under ambient and medium temperature and may not exceed 3 °C . ATEX optional: The ATEX ID depends on the selected pilot valve. The filling valve builds up pressure slowly in the pneumatic systems, i.e. prevents a sudden pressure build-up during a recommissioning after a mains pressure failure or avoids emergency OFF switching. This allows dangerous abrupt cylinder motions to be avoided. Do not position filling valves or filling units upstream of open consumers, such as nozzles, air barriers, air curtains, since these may prevent through connection of components. A change in the flow direction (from air supply on the left to air supply on the right) occurs by rotating installation by 180° about the vertical axis. Please see the operating instructions for further details. |
| Material |
|---|
| Housing | Die cast zinc |
| Front plate | Acrylonitrile butadiene styrene |
| Seals | Acrylonitrile butadiene styrene |
| Threaded bushing | Die cast zinc |
