| Actuating control | double solenoid |
| Switching principle | 4/2 |
| Version | Diaphragm poppet valve |
| Housing | Polyoxymethylene |
| Sealing material | Acrylonitrile butadiene rubber |
| Connector standard | EN 175301-803, form C |
| Protection class | IP65 |
| Port size | EN 175301-803, form C |
| Type | Plug |
| Nominal flow Qn | 200 l/min |
| Compressed air connection input | Ø 6×1 |
| Compressed air connection output | Ø 6 |
| Operational voltage AC at 50 Hz | 230 V |
| Operational voltage AC at 60 Hz | 230 V |
| Activation | Electrically |
| Version | Diaphragm poppet valve |
| Activation | Electrically |
| Pilot | Internal |
| Sealing principle | Soft sealing |
| Working pressure min./max. | 1,8 … 10 bar |
| Note | The maximum operating pressure depends on the ambient temperature. The following values are applicable:-15 °C … 50 °C: Operating pressure 1.8 bar … 8 bar possible.-15 °C … 40 °C: Operating pressure 1.8 bar … 10 bar possible. |
| Control pressure min./max. | 1,8 … 10 bar |
| Ambient temperature min./max. | -15 … 50 °C |
| Medium temperature min./max. | -15 … 50 °C |
| Medium | Compressed air |
| Max. particle size | 50 µm |
| Oil content of compressed air | 0 … 1 mg/m³ |
| Nominal flow Qn | 200 l/min |
| Connector standard | EN 175301-803, form C |
| Protection class with connection | IP65 |
| Reverse polarity protection | Protected against polarity reversal |
| Duty cycle | 100 % |
| Typ. switch-on time | 12 ms |
| Typ. switch-off time | 12 ms |
| Mounting on manifold strip | PRS strip |
| Weight | See table |
| The min. control pressure must be adhered to, since otherwise faulty switching and valve failure may result! The pressure dew point must be at least 15 °C under ambient and medium temperature and may not exceed 3 °C . The oil content of compressed air must remain constant during the life cycle. Use only the approved oils from AVENTICS. Further information can be found in the “Technical information” document (available in the MediaCentre). |
| Versions with voltage of less than 50 V DC do not have a protective ground. |
| Material |
|---|
| Housing | Polyoxymethylene |
| Seals | Acrylonitrile butadiene rubber |
